This little gem I wrote will listen to all interfaces on a computer for CDP packets. Once it has looped all the interfaces any packets it has captured are processed and added to WMI.
Using the attached SMS_DEF.mof we can extract that information and place it in SCCM. Anyone who knows what CDP is will see the benefit immediately. For the rest; CDP (Cisco Discovery Protocol), Cisco devices send out CDP packets every 60seconds each packet contains information about the port it was sent from and the sender. In a nutshell if my computer receives a packet then I can tell which switch I am connected to, what port on that switch and a few other bits and bobs about the switch. e.g. In a test environment I have a Cisco switch which connects to a Cisco IP phone which then connects to my computer, when exe runs I get two entries in WMI, one for the phone and one for the Switch.
The use case is that helpdesk may not know where a user is physically or where they are connected to the network and the user may be experiencing network issues, this would allow a helpdesk tech to locate the switchport the user is connected to and pass that info to the network team for troubleshooting saving both parties the hassle of tracing cables and also allowing reporting on where a user is plugging in over a period of time.
There is still a bit to be done for this but it does generally work.
